Your browser version is too low, it may lead to sites not normally access!
You can use the site to function properly, use these browsers.
Your browser version is too low, it may lead to sites not normally access!
You can use the site to function properly, use these browsers.
The daily inspection of beach bike gears is a key link in ensuring the safe operation of the vehicle and extending its service life. Daily inspection of beach bike gears mainly includes the following aspects:
1. Observe the wear of the tooth surface: Regularly inspect the tooth surface of the gear to see if there is any abnormal wear or pitting. Abnormal wear may indicate that the gear is approaching failure and needs to be replaced in a timely manner.
2. Check the adhesion of the tooth surface: If the oil film between the tooth surfaces disappears under good lubrication conditions, causing direct contact and bonding between the metal surfaces of the gear, it may be due to poor lubrication conditions. The lubrication system should be checked and improved.
3. Pay attention to gear noise and vibration: If abnormal noise or vibration is found during gear operation, it may be due to severe gear wear or other faults, and detailed inspection and maintenance should be carried out.
4. Lubrication of gears: Ensure the quality and quantity of lubricating oil in the gearbox, regularly replace the lubricating oil, and pay attention to keeping the lubricating oil clean to reduce gear wear.
5. Professional testing: If conditions permit, professional equipment such as vibration analysis, torque testing, and magnetic particle inspection can be used regularly to test gears, in order to more accurately determine their health status.
6. Regular maintenance: According to the recommendations in the vehicle manual, regularly lubricate and inspect the gears to maintain the good condition of the gearbox.
7. Observe driving performance: During daily driving, pay attention to the acceleration, deceleration, and turning performance of the vehicle. If any abnormal reaction is found in the transmission system, stop immediately for inspection.
8. Maintenance habits: Avoid excessive load and sudden acceleration and braking to reduce gear wear. Meanwhile, avoid driving on uneven roads to prevent unnecessary impact and damage to the gears.
